Carrier operating and maintanance Provozní pokyny stáhnout pdf (Strana 16)

6.3. Unit with Different Widths

For units with different widths, there are four different

situations. For an indoor installation the method desc-

ribed below applies to all situations.

Indoor Installation

The top section includes a projecting cross beam that

is effectively as wide as the bottom section.

• Check that the cover strip at the ends of the bottom

section is installed in the correct place.

• Position the top section as indicated in the dimen-

sional drawing.

• Screw the projecting cross beam of the top section

to the corner posts of the bottom section.

Figure 33.

Fixing profile, width direction, unit with

intermediate base frame

View of width direction, equal casing length (B)

• If the top section is shorter than the bottom sec-

tion, the unit ends should be finished as described

below.

Figure 34.

Unit with shorter top section with interme-

diate base frame

• Cut the connection profile supplied to the correct

length and mount it to the unit ends as described

below

View of width direction if the top section is shorter

Figure 35.

Roof finish, shorter top section with inter-

mediate base frame

• A longer top section needs no further finish at the

top.

Figure 36.

Unit with longer top section with interme-

diate base frame

NOTE: For an outdoor installation, seal all joints

resulting from the mounted profiles. This applies

to both corner and butt joints.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 40 41

Žádné komentáře

Carrier operating and maintanance Provozní pokyny Strana 16