Carrier 60 Uživatelský manuál stáhnout pdf (Strana 13)

INSTALLING UPPER ANCHORAGE STRAP

A. Locate the child restraint anchor

ttinginthecarthatisdirectly

behind the seat location in the

rear seat you have chosen.

Refer to the car owner’s manual

for the location (If there is no

anchoragettingthenrefertopage

49 for instructions in adding an

anchortting.)ConnecttheUpper

Anchorage Strap Attachment Clip

to the Anchor Fitting.

Lengthen the strap by pressing

the adjuster button (1) and pull

the strap (2) so that the strap is

ready to attach to the Carrier.

THIS UPPER ANCHORAGE

STRAP MUST ALWAYS BE

FITTED WHEN THE INFANT

CARRIER IS USED IN THE CAR.

B. While the Infant Carrier is out of the car, store the upper anchorage

strap between the stabilising bar and the car seat back so that it will

be ready for use when the Infant Carrier is put back in the car.

Always attach hook

and remove slack.

C.Iftheseatbeltwillnotstaytight,thentthe3-bargatedbuckleto

the lap-sash belt to prevent loosening. See pages 52 to 53.

Attachment Clip

Car's Anchor Fitting

HOW TO INSTALL

24 25

Fully press Adjuster Button (1)

while pulling Upper Anchorage

Strap (2) to lengthen.

HOW TO USE

PLACING BABY IN INFANT CARRIER

When positioning baby into Infant Carrier make sure baby’s back

isfullysupportedontotheatsectionandthebaby’snappy

area (bottom) is resting in the bottom curvature as shown. It is

recommended that bulky nappies are not used when baby is travelling

in the Infant Carrier as they can cause incorrect positioning of the

baby’s back in the Infant Carrier.

Bottom curvature

of Infant Carrier

Flat section

of Infant

Carrier

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 28 29

Komentáře k této Příručce

Žádné komentáře

Carrier 60 Uživatelský manuál Strana 13

Komentáře k této Příručce

Související produkty a manuály pro ne Carrier 60