
Subbase
Part No.: SUB-BASE
This decorative subbase supports the unit and routes
electrical wires. The subbase mounts to the wall sleeve
and comes with adjustable legs and side skirting to
provide a finished appearance.
A subbase is required for installations where the wall
sleeve extends 4 or more inches into the room or the
wall is less than 2 in. thick. The minimum clearance
between the bottom of the sleeve and the floor is
3
1
⁄
4
in., and the maximum clearance is 5
1
⁄
2
inches. The
subbase assembly comes with two leveling legs. See
the wall sleeve installation information for leveling
instructions.
The subbase is designed to accommodate various elec-
trical configurations. Internal partitions and knockouts
allow easy and flexible field-installation of electrical
connections. The subbase supports both hard-wire and
cord connections. Electrical receptacles must be field-
supplied.
The subbase, along with a field-supplied receptacle,
must be installed if the 265-v Cord-Connection Kit
(Part Nos. PLUG-265V-15AMP, PLUG-265V-20AMP,
or PLUG-265V-30AMP) is used. See this page for more
information.
Subbase Assembly
265V Cord-Connection Kit
Part No.: PLUG-265V-15AMP
Part No.: PLUG-265V-20AMP
Part No.: PLUG-265V-30AMP
This 265-volt cord connection kit is an alternative to a
265-volt permanent hard-wire connection. The kit con-
tains an 18-inch cord and a unit-mounted plug con-
nection. This field-installed accessory connects easily
to the right side of the unit and plugs into a receptacle
in a subbase. The subbase, described in this section,
and a field-supplied receptacle are required if this cord-
connection kit is used.
265V Cord Kit
17
Komentáře k této Příručce