Carrier 40CS024 Manuál s instrukcemi stáhnout pdf (Strana 10)

5. Cut the required openings in the insulation material on the

back of the unit.

6. Mount the indoor unit on its mounting bracket, as previously

described.

7. Seal any gaps between the back of the unit and the wall using

a sealing material.

8. Install the grille into the wooden frame and attach it to the

frame using two wood screws.

9. Finish the installation by performing all the necessary steps

located throughout this instruction.

Step 11—Air Feedback System Installation (Optional)

(Two-Way Air Conditioner)

See Fig. 23.

The air feedback grille is installed when air from the adjacent room

is to be sampled by the thermostat when installed as a console.

1. Affix a gasket around the air feedback opening at the rear of

the air conditioner (approximately 12-in. from the opening).

2. Drill a hole in the shared wall to insert the return air tube.

3. Mount the indoor unit on its mounting bracket.

4. Insert the tube into the hole until it reaches the opening at the

rear of the unit.

5. Insert the grille on the end of the tube.

6. Complete the installation by attaching the plastic frame to the

wall using screws.

Fig. 19—Fastening Left and Right Sides to Air Conditioner

A01097

PIPE COVER

WIDE

SIDE

Fig. 20—Mounting Indoor Unit onto Ceiling Bracket

A01098

SLIDE THE

AIR CONDITIONER

INTO THE

MOUNTING STRIPS

MAKE SURE

THAT THE

PROTRUDING

PARTS OF THE

SIDE STRIPS FIT

INTO THE

RUNNERS ON

THE MOUNTING

BRACKETS

PROTRUSION

FASTEN THE 4 SAFETY

SCREWS ON THE SIDES OF

THE AIR-CONDITIONER

Fig. 21—Drainage Tube Routing Option

A01099

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Komentáře k této Příručce

Žádné komentáře

Carrier 40CS024 Manuál s instrukcemi Strana 10

Komentáře k této Příručce

Související produkty a manuály pro Split-systém klimatizace Carrier 40CS024