Carrier 558D Uživatelský manuál stáhnout pdf (Strana 8)

Dorner Mfg. Corp. 8 851-558 Rev. D

Fixed and Adjustable Height Stands

Installation

2. Slide (2) hex nuts (Figure 13, item 1) along with boot

assembly (Figure 13, item 2) into outer slots of stand

assembly (Figure 13, item 3). Tighten button screw

(Figure 13, item 4) to 150 in–lb (17 N–m).

Figure 13

3. Repeat steps 1 and 2 for opposite stand leg.

Optional Fine Adjustment Kit

Required Tools

• 6 mm Hex Key Wrench

Typical Components (Figure 14):

Figure 14

1. Loosen stand boot screws (Figure 15, item 1).

Figure 15

2. Raise stand leg (Figure 16, item 1) until it is above fine

adjustment bolt assembly (Figure 16, item 2). Insert

fine adjustment kit (Figure 16, item 2) into stand leg

(Figure 16, item 1).

Figure 16

WARNING

Failure to secure screws (Figure 13, item 4)

may cause conveyor sections to drop down

causing severe injury.

TIGHTEN SCREWS (Figure 13, item 4) AFTER

ADJUSTMENT.

1 Adjustment Kit (2x)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

Carrier 558D Uživatelský manuál Strana 8